Trends for the bending machine is estimated in two: one is that the end of the year 2009 can be put in place national measures, in the second half after the emergence of a new development. From my current understanding of the countries to take measures 4 trillion yuan, really only use the grant 20 days time off, but should also see a lot of problems. Implemented by the end of 2008 was 100.5 billion yuan more real.

This machine used to make the steel plate into barrel shape\Circular shape\Conical sharp, etc. The upper roller can move vertically as well as horizontally, it can finish the pre-bending work and coiling work at the same machine. The upper roller is drum-type design, so it has the anti-deformation function.

W11s-60*3000 Roll bending machine Parameter: Main technical data: Upper roller adding pressure 750tons Max width of roll board 3000mm The length of working rolls 3100mm Max thickness of plate 60mm(carbon steel σs≤245Mpa) Max thickness of plate pre-bending

The machine adopts 3-roller symmetrical structure with the upper roller moving vertically in the center between the two lower rollers, which is achieved through the drive of the screw, the unt, the worm and the lead screw. The two lower rollers rotates, and provides the plate materials with torque through the engagement of the output gear of the moderator with the gear of the lower rollers

Character of Mechanical 3-Roller Symmetrical Plate Rolling Machine W11 series This machine structure pattern three roller symmetrical type, have roller act as vertical sport of going up and down in two roller central symmetrical position, but acquisition through the mother  worm transmission of pole silk of silk,